Domestic oil storage tank installation

Nationwide Deliveries. Competitive Prices. Trusted Brands. Bank Grade Security. Clear Pricing. Expert Advice. Oil Tank Outlet Position. My Wish List. Last Added Items. Add to Cart Add to Cart. Remove This Item. Go to Wish List. About Us. AdBlue Tank Capacities. Coal Bunker Material of Construction.

Coal Bunker Capacities. Diesel Tank Capacities. Clean up costs for oil spills are only covered in very limited circumstances and again not for gradual leaks. In all cases you are required to keep the tank in good repair and declare any problems at the outset. For more a comprehensive cover it is best to take out a specialist Oil Spill policy.

This scope for claims is much wider but the insurer will require an annual inspection of the tank by an Oftec engineer and that any recommended works are carried out within 60 days — see our Guide to domestic heating oil spills and insurance.

If you are advised to replace your tank because your boiler is at risk of irrevocable damage or the tank is in such poor condition a leak is imminent, then the costs of preventative works in the short term will be much less than the cost of the damage caused as a consequence of not replacing.

If the cost is too much, you might want to consider using a supplier that offers stage payments for a new tank as part of their oil supply services see below. Whilst it is possible to fit a single skin tank, most new domestic tanks are integrally bunded.

It is much more straight forward to fit an integrally bunded tank as it reduces the risk of non-compliance with an unsurveyed water source. The three main types of tank are as follows:. For single skin tanks this takes the form of a reinforced concrete or masonry bund see below. This means that an outer containment forms part of the tank construction removing the requirement for a masonry or concrete containment.

Building control and environmental regulations give specific guidance for how a new oil tank should be installed and sited.

Your attending engineer will be able to give you specific guidance according to your circumstances. The following requirements are given as a guide:.

Specific regulations govern the installation of oil supply pipes in order to prevent leakages and ensure system reliability. Any air gaps or loss of oil supply due to a faulty installation will result in the boiler cutting out and an engineer visit to reset it. Oftec provide some useful guidance for guarding against theft, a few practical solutions are summarised here:.

Their certification is passed on to your building control. It is of course possible for a non-competent person to install the tank and for you to notify building control yourselves.

The works will be inspected by building control directly before they are signed off. A member of our team is always here to help. If you would like to contact A1 Tank Services to discuss your requirements please click the button below to go to our contact page. Web Design by BB Solutions.

Early detection can save thousands of dollars in cleanup and environmental An outside tank is subjected to the elements including extreme temperatures, rain, snow, ice, external corrosion, condensation which leads to internal corrosion as well as vandalism. All of these factors contribute to a reduced life expectancy, higher maintenance costs and a greater possibility of an oil leak Inside tanks are not subjected to frozen product Inside tanks provide better performance and less maintenance for oil heating systems because the fuel is kept at a constant temperature Indoor Installations: Tanks shall be installed on the lowest floor of the dwelling Inside tank s shall be located not less than 5 feet 1.

If feasible, maintain a minimum separation of 2 in 50 mm Tanks located in garage bays shall be provided with adequate protection from vehicles Outdoor Installations: Aboveground outside tanks shall be located in conformance with the following: Tanks must not block building entrances or windows including basement A single tank can be placed next to a propane cylinder with a capacity of gallon l or less. If the capacity of either tank exceeds these volumes, the separation shall be not less than 20 feet 6 m.

Tank s with a gallon 1, l capacity or less shall be not less than 5 feet 1. Variances may be requested from the authority having jurisdiction of the site where the property is located Tank s over gallon 1, l capacity shall be not less than 10 feet 3 m from a property The tank s should be located down grade from any domestic drinking water well If possible, tanks should not be located directly under house eaves where they may be subject to falling snow and icicles or increased external pitting from dripping water Tanks should not be placed in intimate contact with the building since leaves and other organic matter can accumulate and cause external corrosion of the tank Protection from Vehicle Traffic Tanks located in areas exposed to vehicular traffic eg.